Description
Reproduction “Final Design” turn signal switch for 1967-71 Mopar A, B, C, & E-Body models without tilt wheel. This switch comes with metal connectors attached to the ends of the wires and includes the plastic connector for a solder and splice-free plug-in installation. 2-3/4″ from outside of arm to outside of arm. This switch is modeled after the final design by Chrysler Corporation who changed the design several times over the years. Note the wires on the actuator. Please verify that this switch is correct for your application before purchasing. Saginaw also produced a switch that was used in some of the same models listed below. The Saginaw switch is radically different, as are the bolt patterns. These two switches are not interchangeable.